Turning the Repair Service off

Stopping the Repair Service stops the service after any repairs in progress complete the currently running repair cycle.

Stopping the Repair Service cancels any pending repairs. When the Repair Service is turned back on again, a new cycle of repairs begins.

Turn off the Repair Service if you need to adjust the Time to completion parameter value. If for some reason you need to perform a manual repair operation, be sure to turn the Repair Service off.
Warning: Do not run a manual repair operation from Node administration or using the command line while the Repair Service or NodeSync Service is On.

While the Repair Service is off, the Repair service not enabled rule in the Best Practice Service will continue to fail unless the rule has been turned off.

Repair Service Best Practice Rules

Procedure

  1. In the left navigation pane, click Services.
  2. Click Details for the Repair Service.
  3. Click the Settings tab.
  4. Click the On button to toggle the setting to Off.
    Any repairs that were in progress when the Repair Service was stopped continue running until completion. Any pending repairs are cancelled. The Status for the Repair Service on the Services page displays Off.