Add or remove nodes, datacenters, or clusters
- Add nodes to vnode-enabled cluster
-
Steps to add nodes to a datacenter in an existing vnode-enabled cluster.
- Add a datacenter to a cluster using a designated datacenter as a data source
-
Add a datacenter to an existing cluster using a designated datacenter as a data source.
- Replace a dead node or dead seed node
-
Steps to replace a node that has died for some reason, such as hardware failure.
- Replace a running node
-
Two methods for replacing a node with a new node, such as when updating to newer hardware or performing proactive maintenance.
- Move a node from one rack to another
-
Methods for moving a node from one rack to another.
- Decommission a datacenter
-
Steps to properly remove a datacenter so no information is lost.
- Remove a node
-
Reduce the size of a datacenter.
- Change the IP address of a node
-
Change the IP address of a node.
- Switch snitches
-
Steps for switching snitches.
- Chang keyspace replication strategy
-
Change the replication strategy of a keyspace from SimpleStrategy to NetworkTopologyStrategy.
- Migrate or rename a cluster
-
Migrate or rename without interruption of service.
- Add single-token nodes to a cluster
-
Steps for adding nodes in single-token architecture clusters, not clusters using virtual nodes.
- Add a datacenter to a single-token architecture cluster
-
Steps for adding a datacenter to single-token architecture clusters, not clusters using virtual nodes.
- Replace a dead node in a single-token architecture cluster
-
Steps for replacing nodes in single-token architecture clusters, not vnodes.
